Apply and Care

Prepare your look then remove lashes gently from the tray. Only handle from the band, do not remove by the fur. Measure the lashes to the base of your natural lash line and trim any excess. Apply adhesive along the entire band and wait until the glue becomes tacky. Place lashes along your natural lash line starting from the outer corner. Hold in place for a few seconds to allow it to bind.
Important: Do not use alcohol based cleaners on the mink lashes as it may weaken the band.
Use an oil free makeup remover or micellar water to remove lashes from your eyes. Using a cotton swab, gently run the saturated tip along the band of the lashes until the adhesive starts to dissolve and becomes malleable and easy to release. Gently push down the lashes by the band area. The band should come off your eyes effortlessly, avoid pulling on the individual strands of fur. Clean the lash adhesive on the band after each use and store back into your lash box to avoid dust and dirt.
Share This
Free USA & CDN Shipping On Orders $40+
Free International Shipping On Orders $50+